Table of Contents
Advertisement
Vending-Box COMPANY
The connection of the power supply
through the socket at the back of the
dispenser is an emergency stop switch because of
lack of access to the min switch when the
dispenser door is closed. Remember to ensure an
access to the power supply cable so that it can be
disconnected any time
User's panel controller
6.3
The controller is responsible for the user's panel
functioning. It is located on the inner side of the right
door. It is protected by a cover, which can be removed
with the use of a cross-head screwdriver.
1.
SIM card socket with a lock
2.
3V battery
3.
Power supply diode
6.4
Touch Panel
The basic interface used for communication with the
device is the user's panel located in the right door of the
dispenser. The view of the panel is showed below:
1.
Function touch button,
User's panel display,
2.
3.
The scan field of proximity card reader
For identification of the user, there is a proximity card
reader located below the display behind a glass panel.
Depending on the reader, the range of the scan field is
from a couple to several centimeters. All information
for the user are displayed on the 7'' screen. On both
sides of the screen and below it, there are fifteen touch
buttons. Functions of the buttons depend on the
information displayed on the screen. The touch buttons
react to human fingers' touch. It is possible to touch the
buttons in thin gloves but it may make the quality of the
operation worse. You must not use a stylus or other
pointing elements, which might not be recognized by
the touch buttons, and in particular situations they may
scratch the surface or even break the glass surface of the
user's panel.
7 Transport
Original package secures the device against abrasion or
minor hits. However, in order to avoid damages,
particular safety measures should be taken
during transportation. The device is adjusted to
transportation directly by a forklift.
The device may be lifted on each side. However,
remember that the fork of the forklift is placed under the
whole machine and extends out of its contour.
During transportation and storing, no other objects may
be placed on or in the device.
In transportation of the device, because of possible
vibrations and inertia of the rotating feeder, the brake
should be unlocked so the drum could rotate freely.
Otherwise the brake lock mechanism may get damaged.
It is recommended to be careful when placing
the machine on the floor. It should be done
gently in order to avoid excessive shock.
Even when placing the device in the final destination, a
forklift or pallet truck matching the device weight and
dimensions should be used. You must not move the
machine.
Because the center of gravity is located high, it
is necessary to fix the device for transportation
with securing belts. Before lifting the machine,
make sure if its weight is within the range of the used
lift. Information on the weight of the device is to be
found on the rating plate.
In case of longer storage of the machine, it is
recommended to periodically (every second month)
connect the device to the outer power supply for 48
hours in order to charge the battery installed in the
machine.
8 Environment protection
All the parts should be utilized
according to
the standards of
environment protection.
The
proper
utilization
preserving
valuable
resources and avoiding negative
influence
on
health
environment,
which
may
endangered by inappropriate waste
proceedings.
Model 540
enables
natural
and
be
Advertisement
Table of Contents
