Table of Contents
Advertisement
1-2 Electronics Tray
Removal Procedure
LCD Assembly
1. Tilt the LCD assembly forward and disconnect the cables from the back of the LCD assembly.
a. Disconnect the inverter to
b. Disconnect the
2. Set the lid back down.
3. Remove the four inner
Note:
Hold onto the front of the LCD screen while removing the screws so that the assembly does not fall.
Figure 1-2. Remove the Four Inner Screws
4. Remove the
Speaker
1. Perform a graceful shutdown of the electronics tray.
2. Open the console top.
3. Remove the
Figure 1-3. Disconnect the speaker From the motherboard
OmniTT/AnesthesiaTT Installation and Service Guide/67-2024 Rev D
power
cable.
flat panel
cable.
screws
at the back of the console lid.
LCD assembly
from the LCD housing.
speaker
from the motherboard.
© 2010 Omnicell, Inc.
Advertisement
Table of Contents
