Table of Contents
Advertisement
7. Pull the
(drawer connect board to IUPS cable assembly).
Figure 2-4. Disconnect the ribbon cable and remove the SPC board
8. Remove the
Manual Override Cable
Removal
1. Perform a graceful shutdown of the electronics sled.
2. Remove the
3. Remove all three drawers from the TT cabinet. For help, refer to
page 3-6.
4. Open the
5. Push the
6. Open the lid to the electronics tray.
7. Remove the thermal printer paper and spool.
8. Remove the electronics tray. For help, refer to
© 2010 Omnicell, Inc.
wireway
backward toward the rear of the frame and disconnect the
SPC board
from the wireway.
manual override
cover.
printer
cover.
platen lever
to the left to release the paper.
"Removal Procedure"
"Electronics Tray"
on page 1-9.
OmniTT/AnesthesiaTT Installation and Service Guide/67-2024 Rev D
Frames and Wireways 2-3
Manual Override Cable
ribbon cable
on
Advertisement
Table of Contents
