OmniCell OmniTT Installation And Service Manual page 32

4. Connect the
Figure 3-4. Connect the drawer cable to the drawer connect board
5. Place the
6. Line up the rail with the screw holes on the front of the frame and replace the screws.
7. Connect the drawer controller cable to the
drawer.
8. Secure the drawer
Figure 3-5. Connect the drawer controller cable to the controller board
9. Attach the
screwdriver.
10. Install the slide support bracket.
© 2010 Omnicell, Inc.
drawer cable to the drawer connect
rail into the support slot in the back of the frame.
controller cable cover
slide to the slide support bracket
board.
drawer controller board
with two screws using a T-10 Torx screwdriver.
with three screws and
OmniTT/AnesthesiaTT Installation and Service Guide/67-2024 Rev D
Drawers 3-5
Installation Procedure
at the rear end of the
washers using a Torx T15