Table of Contents
Advertisement
1-16 Electronics Tray
Standardization Changes
Standardization Changes
To standardize the peripherals that Omnicell products use, the Seiko printer and PS/2 keyboards
are being replaced by APS printers and USB keyboards with a numeric pad. The
swapped out in this procedure.
1. Lift and prop-up the lid if it is not already open.
2. Disconnect all console cables.
3. Remove the console.
4. Replace the
Figure 1-27. Cable cover bracket
5. Place new console into position, then prop it open.
6. Re-connect the cables. Most will go back where the old cables were with a couple of exceptions.
The
The
Move the
OmniTT/AnesthesiaTT Installation and Service Guide/67-2024 Rev D
cable cover bracket
with the new, wider one using three screws.
contrast cable
goes into J33 instead of J32.
USB keyboard cable
goes to the USB port (vs. the PS/2 connection).
jumper
on JP1 from pins 1-2 to 3-4.
console
is
© 2010 Omnicell, Inc.
Advertisement
Table of Contents
