Table of Contents
Advertisement
8. Connect the contrast cable to J31 on the motherboard.
Figure 1-25. Connect the Contrast Cable to J31 of the Motherboard
9. Connect the LCD data cable to J37 on the motherboard
Figure 1-26. Connect the LCD Data Cable to J37 of the Motherboard
10. If a card reader is present and needs to be reconnected:
a. Connect the card reader serial cable to J47 on the motherboard.
b. Connect the card reader power cable to the back of the card reader serial connector.
c. Insert card reader power cable pins into the disk drive power connector.
d. Align the red-stripe pin to the red cable and the gray-stripe pin to the gray cable in next
spot.
© 2010 Omnicell, Inc.
OmniTT/AnesthesiaTT Installation and Service Guide/67-2024 Rev D
Electronics Tray 1-15
Electronics Tray
Advertisement
Table of Contents
