Bracket Unit; Tiller Handle; Assembling The Tiller Handle - Yamaha F25C Service Manual

BRKT

Assembling the tiller handle

1. Install the engine stop lanyard switch 1
to the tiller handle bracket 2. Tighten the
nut to the specified torque.
2. Install the throttle cables 3 and 4 to the
throttle shaft 5.
A
3
4
5
Engine stop lanyard switch nut:
2 N·m (0.2 kgf·m, 1.5 ft·lb)
3. Install the shift lever to the steering
bracket 6.
4. Install the washers and bushings into the
steering bracket 6.
5. Install the tiller handle bracket to the
steering bracket 6, tighten the tiller han-
dle bracket nut 7 to the specified torque,
and then tighten the self-locking nut 8 to
the specified torque.
C
A
6
7-3

Bracket unit

2
1
S6D57020
9
0
7 B
8
S6D57030
NOTE:
• Route the engine stop lanyard switch lead
9 and throttle cables 0 and A as shown.
• Install the corrugated tubes B so that they
contact the tiller handle bracket C.
Tiller handle bracket nut 7:
10 N·m (1.0 kgf·m, 7.4 ft·lb)
Self-locking nut 8:
22 N·m (2.2 kgf·m, 16.2 ft·lb)
6D55F11