Table of Contents
Advertisement
Chapter 2
Installing Cisco MGC Node Manager
About Client Workstation Software
Client workstations must have Java 1.3 and Netscape 4.76 installed to use CiscoView as a client. (Other
browsers may work but have not been verified.) Netscape 4.76 is installed with Cisco EMF. The correct
version of Java 1.3 is packaged with CiscoView. When you launch the CiscoView server the first time,
you will be prompted to download and install the Java 1.3.1 version bundled with the
plugin-131-sparc.tar CiscoView server. Follow the instructions displayed to download and install this
plugin.
To use the CiscoView server, we also recommend that you install the latest J2EE Solaris patch cluster
which can be found at the following URL:
http://sunsolve.sun.com/pub-cgi/show.pl?target=patches/patch-access
Task 8: Install Cisco EMF 3.2
For basic installation, follow the procedure described in Chapter 2of the Cisco EMF Installation and
Configuration Guide at:
http://www.cisco.com/en/US/products/sw/netmgtsw/ps829/products_installation_and_configuration_g
uide_chapter09186a00801a8e14.html
For a management server, choose Server Installation. For a presentation server (a client), choose
Remote Client Installation. You do not need a license on a client machine.
After installing the base 3.2 version, go on to
you are using SSH for secure communications with SSH-enabled network components, continue with
Installing SSH. Finally, start the Cisco EMF Server, as described in
page
Installing Cisco EMF Patches
Cisco MGC Node Manager requires Cisco EMF Service Pack 7 and 7.1. Refer to the Release Notes to
check on any additional patches required.
To install Service Pack 7 and 7.1, follow these steps:
Determine your current Cisco EMF version and patch level:
Step 1
cemf install -show
Go to the following URL:
Step 2
http://www.cisco.com/cgi-bin/tablebuild.pl/cemf-sp32-sp1
Download CEMF 3.2 Service Pack 7 software, CEMF3.2P7.tar.Z, to a directory on your hard drive.
Step 3
Step 4
Download and read the CEMF 3.2 Service Pack 7 Release Note, CEMF3.2P7DepRelNote.pdf.
Step 5
Download CEMF 3.2 Service Pack 7.1 software, CEMF3.2P71.tar.Z, to a directory on your hard drive.
Step 6
Download and read the CEMF 3.2 Service Pack 7.1 Release Note, CEMF3.2P71DepRelNote.pdf.
Step 7
Follow the patch installation instructions in the Release Note and in the Cisco EMF Installation and
Configuration Guide at the following location:
http://www.cisco.com/en/US/products/sw/netmgtsw/ps829/products_installation_and_configuration_g
uide_book09186a00801a8e04.html
OL-4062-02
2-8.
Performing a New Installation of the Cisco MGC Node Manager
"Installing Cisco EMF Patches" section on page
"Starting Cisco EMF" section on
Installation Guide for the Cisco MGC Node Manager 2.5(2)
2-7. If
2-7
Advertisement
Table of Contents
