Cisco MGC Node Manager Installation Manual page 28

Upgrading from Previous Cisco MGC Node Manager Versions
Check the
Step 1
Step 2 Have Cisco EMF and Cisco MGC Node Manager running. Change to the <cemf_root>/bin directory and
enter ./cemf query to check the current version.
If you are not already logged in as root, enter su - root to become the root user.
Step 3
Step 4 Verify that the Volume Management daemon is running:
Enter the command ps -ef | grep vold. If the daemon is running, you see the following output:
root 363 1 0 May 23 ? 0:01 /usr/sbin/vold
If the daemon is running, go on to Step 5. If the daemon is not running, start the daemon using the
following command:
/etc/init.d/volmgt start
Verify that the Volume Management daemon is running with the command provided above. If it is still
not running, contact your system administrator.
Place the Cisco MGC Node Manager installation CD into the CD-ROM drive and enter cd
Step 5
/cdrom/cscocmnm.
Back up your database (see the
Step 6
page 2-20).
Start Cisco MGC Node Manager and in the Map Viewer remove the MGX objects in the
Step 7
MGX-8260-View (refer to the Cisco MGC Node Manager User's Guide, Chapter 5, "Modifying or
Deleting Deployed Objects" at
http://www.cisco.com/en/US/products/sw/netmgtsw/ps1912/products_user_guide_list.html).
Step 8 Close Cisco MGC Node Manager.
Step 9 Install CEMF 3.2 Patch 6 and any later patches specified in the Release Notes.
Enter ./installCSCOcmnm -upgrade
Step 10
The installation begins. During installation, you are asked for various kinds of input, summarized here:
Logfile directory location—Press Enter to accept the default location /var/tmp or type another
•
location and press Enter.
Logfile name—Press Enter to accept the default name CSCOcmnm.log, or type another name and
•
press Enter.
When the installation is complete, verify it according to the instructions in the
Step 11
Installation" section on page
After the upgrade completes, start Cisco MGC Node Manager and do the rediscover the following
Step 12
objects:
All BAMS objects, using the Map Viewer BAMS-View
•
All HSI objects, using the Map Viewer HSI-View
•
Note During the upgrade process, you may see error messages caused by Cisco EMF trying to create
controllers that already exist. These messages may safely be ignored.
Installation Guide for the Cisco MGC Node Manager 2.5(2)
2-18
"Installation Checklist" section on page 1-5
"Uninstalling the Cisco MGC Node Manager Software" section on
2-10.
Chapter 2 Installing Cisco MGC Node Manager
to identify any other tasks needed for the upgrade.
"Verifying the
OL-4062-02