Sealing Splashguard To Floor - Hussmann CW2U-138GE Installation And Operation Manual

3-4 D
RIP

SEALING SPLASHGUARD TO FLOOR

I by local sanitation codes, or if
F REQUIRED
desired by the customer, splashguards may be
sealed to the floor using a vinyl cove base trim.
The size of trim needed will depend on how much
the floor is out of level.
To install the trim to the splashguard:
1. Remove all dirt, wax and grease from the area
of the splashguard where adhesion will be nec-
essary. This is to ensure a good and secure
installation.
Cove Trim
Cement
Splashguard
P/N 428668A
P S
IPING AND PLASHGUARDS
2. Apply a good contact cement to the cove trim
and allow proper drying time according to the
directions supplied with the cement.
3. Install the trim to the splashguard so that it is
lying flush with the floor. D
TRIM TO THE FLOOR
4. If required by local health codes the Cove
Trim may be sealed to the floor, using a sili-
cone type sealer. Sealant must be removed and
replaced when servicing.
O NOT SEAL THE
.