Hussmann IMPACT CW2-EGE Instructions

Shop Around Medium Temperature Convertible Merchandisers
PARTS LIST
Item No. Quantity
1. 2
2. 1
3. 8
4. 8
5. 2
6. 2
7. 2
8. 2
9. 2
10. 12
NOTE: Be sure merchandisers have
been leveled according to the installa-
tion instructions. Carefully unpack and
inspect the CW2 Joint Kit, making
sure there is no breakage or damage.
Be sure factory installed alignment pins
are in place.
NOTE: Apply gasketing to one case
only.
Apply Gaskets – 1 and 2
1
as shown in Figure 1.
• Remove paper backing as
gasket is applied.
• Apply two rows of Gasket 1 to
the center flue foam area only.
• Lap gaskets at lower
corners.
• Check that there are no gaps
between gasket and merchandiser.
• Do not stretch gasket,
especially around corners.
• Do not butt gaskets; always
overlap joints.
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 (Printed in U.S.A.)
®
Description
1 /
Gasket x
2
Donut Gasket
Nut Retainer
Cap Screw 5 /
Cap Screw 5 /
Lock Washer Split Steel
Flat Washer
Hex Nut 5 /
16
Joint Base Plate (end case only)
Thread Cutting Flange Screw (end case only)
CW2-GE/
CW2-XGE
ALL
MODELS
CW2U-GE/CW2U-XGE
1 /
x 180 in.
2
5 / -18
16
BEFORE PIPING CASE.
-18 x 3 /
16 4
- 18 x 1 1 /
16 4
5 /
16
5 /
16
- 18
CW2U-GE/CW2U-XGE
1
2
Figure 1. Installing Gaskets
January 2001
CW2-GE/CW2-XGE
CW2EGE/CW2EXGE
Joint Kit Instruction
Splashguard Brackets
MUST BE INSTALLED
CW2-GE/
CW2-XGE
CW2EGE
CW2EXGE
1
1 2 x 1
/ / In. Gasket
2
Donut Gasket
2
P/N 419410A
1