Vic-2Fxo-M1, Vic-2Fxo-M2, And Vic-Fxo-M3 - Cisco ICS-7750 Description

Chapter 2 Processor Cards Feature Summary
Table 2-10 Technical Specifications for VIC-4FXS/DID Card (continued)
Type
DID homologation
Spare

VIC-2FXO-M1, VIC-2FXO-M2, and VIC-FXO-M3

Technical Specifications
Table 2-11 Technical Specifications for VIC-2FXO Cards
Type
Interface type
Address signaling formats
Signaling formats
Tone disconnect supervision
Power interrupt disconnect
Battery polarity reversal
detection
Physical connector
Number of connectors/ports
78-10360-02
Description
USA (TIA/EIA-15-968), Australia (ACIF S002/S003)
VIC-4FXS/DID=
The VIC-2FXO card is a two-port FXO interface card with battery reversal
detection and caller ID support and is available for the following locations:
VIC-2FXO-M1—North America
•
• VIC-2FXO-M2—Europe
VIC-2FXO-M3—Australia
•
Use these cards to connect to PBXs or key systems and to provide off-premises
connections.
Table 2-11 lists the technical specifications for the VIC-2FXO-M1,
VIC-2FXO-M2, and VIC-2FXO-M3 cards.
Description
FXO
In-band DTMF
Out-of-band pulse (10/20 pps)
Loop start, ground start
Call disconnect on progress tone of less than 600 Hz
Call disconnect on power interrupt of greater than 600 ms
Detection of disconnect supervision and far-end answer supervision
through battery polarity reversal
RJ-11
Two
Voice and WAN Interface Cards
Cisco ICS 7750 System Description
2-35