Playback Your Recordings - Panasonic PV-DV101 Manual

Playback using the LCD Monitor
You can also use the LCD monitor to
playback your recording.
VOLUME KEY
1
LCD-OPEN
Button
2
REWIND
4
SEARCH
STOP
Button
Button
180°
90°
90°
You can place the Palmcorder on a table,
etc. for viewing. Rotate the LCD Monitor
180° and swing it up against the
Palmcorder body as shown.

Playback your Recordings

Playback your Recordings
3
PLAY Button
Built-in
Speaker
PHONE
Jack
Before you begin
• Connect the Palmcorder to a power
source. (See pages 11, 12.)
• Insert a recorded cassette.
• Set POWER to VCR.
1
Press LCD-OPEN to unlock the LCD
monitor and swing open.
2
Press REWIND/SEARCH to rewind
the tape.
3
Press PLAY to start playback.
To adjust the volume:
A
Hold down VOLUME KEY until the
volume setting screen appears.
(See page 20).
B
Rotate VOLUME KEY to adjust the
volume of the built-in speaker. To
remove the volume setting screen, hold
down VOLUME KEY again.
• Adjust the picture on the LCD monitor if
needed. (See page 23.)
4
Press STOP to stop playback.
• When the tape reaches its beginning
during rewind or rewind search, it will
stop automatically.
• If you press PLAY for more than 5
seconds, the Palmcorder will go into
Repeat Playback mode when the
tape reaches its end. The letter "R
will appear in the EVF and LCD
monitor. To exit the Repeat Playback
mode, turn the Palmcorder OFF.
Note
• When a tape recorded in LP mode on
another digital video camera is played
back on this unit, the picture may appear
mosaic.
• Using the LCD monitor reduces battery
operating time.
• You can connect earphones (not
supplied) to the PHONE Jack.
"
R
27