Raider Pro RDP-SBGP20 User Manual page 27

3
Store the battery only in a dry place at an air temperature of + 10 ° C to +
30 ° C.
Store the battery only when it is charged (at least 40% charged).
Remove the battery from the handle, press the button down to do this. Pay attention to the mains voltage when charging the
battery! The mains voltage must correspond to the data on the nameplate of the charger. Appliances marked with 230V can
also be supplied with a voltage of 220V. The green LED will start flashing. Squeeze the battery into the charger.
See explanation table:
Red LED
Off
On
Off
If the battery can not charge, check the following:
• contact voltage
• makes good contact with the charger contacts
If the battery can not be charged again, visit an authorized RAIDER service center.
To make sure that the lithium-ion rechargeable battery will last longer, you must recharge it immediately.
You must recharge the battery when you notice that the power of the cordless tool is decreasing.
16.2. Battery capacity indicator.
Press the button on the battery capacity indicator. It shows the status of the battery charge using 3
LEDs.
All 3 LEDs glow: The battery is charged
2 LED (s) are on: The battery has enough residual charge
1 LED is on: The battery is running low, charge the battery
Indicator status
Green LED Ready for use
The charger is connected to
On the mains and is ready for use;
there is no
battery pack in the charger
Off "Charging
The charger is charging the
battery pack "
On "The battery is charged and
ready for use.
Charging time for 2.0 Ah
battery: 60 min
Action:
Take the battery pack out of the
charger. Disconnect the charger
from
the mains supply."
Explanations and actions
27