Table of Contents
Advertisement
24 www.raider.bg
after tightening the chain as needed, finally tighten firmly with the bolt (B).
Before mounting the guide bar and the cutting chain, you must check the correct position of the cutting blades on
the chain (the correct position of the chain on the bar is shown on the front of the bar). Wear protective gloves when
inspecting and installing the chain to avoid injuries from sharp cutting edges.
It is very important to lubricate the chain before work. Check the chain tension and adjust if necessary.
You need to check and adjust its tension quite often, as the loose chain can be easily removed from the rail, wears out
faster or leads to rapid wear of the guide bar.
Tension of the cutting chain
During operation, the cutting chain stretches or contracts. The tension of the cutting chain changes. During operation, it
is necessary to regularly check the tension of the cutting chain and, if necessary, to additionally stretch it.
Lubrication of the cutting chain
-Switch off the wood cutting machine and remove the battery.
-Place the wood cutting machine on a flat surface so that the sprocket cover points upwards.
-Clean the guide bar and cutting chain with a small brush, soft brush or resin solvent.
-Apply multi-purpose oil in the area (1) between the guide bar and the cutting chain.
- Insert the battery.
-Turn on the machine. The multifunctional oil is distributed on the cutting chain. The cutting chain is lubricated.
Do not use used or regenerated oil, as this may damage the oil pump. Use EP90 oil all year round.
Switching the machine on and off
Hold the garden pruner with both hands during start-up and operation.
Switching on - we press the safety lock (7), and then the switch trigger (1).
Switch off - release the trigger switch (1). Releasing the trigger switch (1) stops the garden pruner. See the sample
figure
:
►Hold the garden pruner with one hand in the gripping area (1) of the main handle so that the thumb covers the
handle.
►Hold and guide the garden pruner with the other hand to the gripping point (2).
►Press and hold down on the lock button (3) with your thumb.
►Press the start switch (4) with the index finger and keep it pressed.
The garden pruner accelerates and the cutting chain is driven. The anti-switch button (3) can be released.
Lubricants used to lubricate the chain.
The durability of the chain and the guide bar of the garden pruner largely depends on the quality of the lubricant used.
Only lubricants designed for chaingarden pruners must be used.
Used or regenerated oil should never be used to lubricate the saw chain.
Chain guide bar.
Advertisement
Table of Contents
