Table of Contents
Advertisement
PROBLEM
Dishwasher
will not start.
Lower
spray arm
rotates with
difficulty.
Cover of
detergent
dispenser
cannot be
closed.
Remnants
of detergent
stuck inside
dispenser.
Water
remains
inside
dishwasher
after wash
has
ended.
Foaming.
Display
shows the
letters F, L, P,
C or S.
24
TROUBLESHOOTING
POSSIBLE CAUSE
No power.
The door is not properly
closed.
Water tap not turned on.
Blocked strainer in water
inlet hose.
Spray arm holes are
blocked by small items or
food particles.
Detergent compartment
has been overfilled.
Detergent dispenser is
clogged with remnants of
detergent.
Compartment was damp
when filled with detergent.
Drain hose is crimped, bent,
or blocked.
Pump is jammed.
Filter(s) blocked.
Incorrect amount or type of
detergent used.
Too much egg in the wash
load.
Rinse aid dosage level too
high.
Rinse aid spills not wiped
up.
Dishwasher is in Technician
Mode.
WHAT TO DO
Ensure the dishwasher is plugged in and
the power supply is turned on at the wall.
Close the door.
Ensure water is connected and turned on.
Check the strainer and clean if
necessary—it is located where the water
inlet hose screws into the tap.
Clean the spray arm. See 'Care
and cleaning' for instructions.
Remove detergent until the cover can be
closed.
Wipe dispenser out with a damp
cloth. Dry the dispenser before adding
detergent.
Wipe dispenser out with a damp
cloth. Dry the dispenser before adding
detergent.
Check the drain hose and straighten if
needed.
Call your Fisher & Paykel Authorised
Service Centre or Customer Care.
Clean the filter(s). See 'Care and cleaning'
for instructions.
See section 'Adding detergent' or consult
the detergent manufacturer's instructions.
Increase the amount of detergent.
Decrease the rinse aid dosage.
Ensure that all rinse aid spills are wiped
up when they occur.
Touch and hold
to exit.
If the Dishwasher remains in Technician
Mode call Customer Care
Advertisement
Table of Contents
