Table of Contents
Advertisement
If the dishwasher malfunctions, it will display a fault code and beep. Check the following
table below to see if you can correct the fault yourself.
FAULT
CODES AND
DESCRIPTIONS
A20
Drain fault
A10
No water
22
FAULT CODES
POSSIBLE CAUSES
Drain hose is
crimped or bent.
The waste water is
not draining out.
The turbidity sensor
is dirty and requires
cleaning.
Water tap not
turned on.
Insufficient water
supply pressure.
Water inlet hose is
crimped or bent, so
no or not enough
water gets to the
dishwasher.
Drain hose is not
connected correctly.
WHAT TO DO
Check the drain hose and straighten if needed.
Ensure that the drain hose is connected in
accordance with the installation instructions.
Gently clean the turbidity sensor with a soft
brush (ie toothbrush) to remove any buildup.
Turbidity
sensor
Ensure the water is connected and turned on.
Touch
to restart the dishwasher.
Check household water pressure.
Check the water inlet hose and
straighten if needed. Touch
dishwasher.
Ensure that the drain hose is connected in
accordance with the installation instructions.
to restart the
Advertisement
Table of Contents
