Required Equipment; Unpacking And Inspecting The Switch - Cisco 5000 Series Hardware Installation Manual

Preparing for Installation
Caution
•

Required Equipment

Before beginning the installation, ensure that the following items are ready:
•
•
•
•
•
The following additional items (not found in the accessory kit) are required to ground the chassis:
•
•
•

Unpacking and Inspecting the Switch

When handling switch components, wear an ESD strap and handle modules by the carrier edges only.
Caution
An ESD socket is provided on the chassis. For the ESD socket to be effective, the chassis must be
grounded through the power cable, the chassis ground, or the metal-to-metal contact with a grounded
rack.
Keep the shipping container in case the chassis requires shipping in the future.
Tip
The switch is thoroughly inspected before shipment. If any damage occurred during transportation or
Note
any items are missing, contact your customer service representative immediately.
Cisco Nexus 5000 Series Hardware Installation Guide
3-4
S e n d c o m m e n t s t o n 5 k d o c s @ c i s c o . c o m
To prevent loss of input power, ensure the total maximum loads on the circuits supplying
power to the switch are within the current ratings for the wiring and breakers.
Use the following screw torques when installing the switch:
Captive screws: 4 in-lb
–
M3 screws: 4 in-lb
–
M4 screws: 12 in-lb
–
10-32 screws: 20 in-lb
–
12-24 screws: 30 in-lb
–
Number 1 and number 2 Phillips screwdrivers with torque capability
3/16-inch flat-blade screwdriver
Tape measure and level
ESD wrist strap or other grounding device
Antistatic mat or antistatic foam
Grounding cable (6 AWG recommended), sized according to local and national installation
requirements; the required length depends on the proximity of the Cisco Nexus 5548P switch or the
Cisco Nexus 5000 Series switch to proper grounding facilities
Crimping tool large enough to accommodate girth of lug
Wire-stripping tool
Chapter 3 Installing the Cisco Nexus 5500 Platform or 5000 Series Switch
OL-15902-01