Cisco 5000 Series Hardware Installation Manual page 70

Installing the Cisco Nexus 5548 Chassis in a Cabinet or Rack
To install the switch in a cabinet or rack using the rack-mount kit provided with the switch, follow these
steps:
Install the front rack-mount brackets as follows:
Step 1
Position a front rack-mount bracket against the chassis and align the screw holes as shown in
a.
Figure
Repeat with the other front rack-mount bracket on the other side of the switch.
b.
Figure 3-1
1 Front rack-mount bracket
2 Rack-mount guides
Install the rack-mount guides on the switch as follows:
Step 2
Position one of the rack-mount brackets against the side of the switch and align the screw holes. See
a.
Figure
Repeat with the other rack-mount bracket on the other side of the switch.
b.
Attach the slider rails to the rack as shown in
Step 3
depending on the rack rail thread type. For racks with square holes, insert the 12-24 cage nuts in position
behind the mounting holes in the slider rails.
Repeat with the other slider rail on the other side of the rack.
a.
Use the tape measure and level to verify that the rails are horizontal and at the same height.
b.
Cisco Nexus 5000 Series Hardware Installation Guide
3-6
S e n d c o m m e n t s t o n 5 k d o c s @ c i s c o . c o m
3-1. Attach the front rack-mount bracket to the chassis with six of the M4 screws.
Attaching Front Rack-Mount Bracket to the Cisco Nexus 5548 Switch
1
3-1. Attach the bracket to the switch with two of the flat-head M4 screws.
Chapter 3 Installing the Cisco Nexus 5500 Platform or 5000 Series Switch
2
3 Slider rail
Figure 3-2. Use two 12-24 screws or two 10-32 screws,
3
OL-15902-01