Vesa Mounting; Panel Mounting - Maple Systems OMI6912A Operation Manual

OMI Operations Manual: OMI6900 Series

VESA MOUNTING

The OMI6900 Series offers VESA mounting as an option. VESA 100 x 100 mm threaded inserts are located on the
rear of the unit. Use the M4 threaded mounting screws included with the VESA mounting hardware to mount the
OMI6900 as illustrated in the figure below.
Use VESA mounting hardware suitable for your intended application; Maple Systems is not responsible for damage
to unit, mounting surface, or to other components caused by improper mounting.

PANEL MOUNTING

In addition to VESA mounting, the OMI can be mounted in a panel using the mounting holes located on the sides
and top of the unit. Use the included clamps to fasten the OMI6900 to a panel, cut out to the proper dimensions on
the datasheet corresponding to your display size.
Tighten the panel bolts with a torque force between 7 ~ 8.5 inch/lbs. to ensure an adequate seal. Torque values
outside this range may negate NEMA or IP rating, or cause damage to the unit or panel.
Maple Systems is not responsible for damage to unit, mounting surface, or to other components caused by
improper mounting.
Note: The image above is a representative image of the panel mounting process; your specific OMI6900 Series unit
OMI Operations Manual: OMI6900 Series
may differ in appearance, but mounting is functionally similar.
26
26