Maple Systems HMC7070A-M Quick Start Manual

Quick Start Guide
HMC7070A-M
Description:
HMC7070A-M- 800 x480 pixels, 7" Color TFT, with five
expansion slots, an Ethernet port and two serial ports
Contents:

1 HMC7070A-M

1 plastic bag containing four mounting clamps (each
clamp consisting of cap nut, bolt, and clamp)

1 three prong green power plug
 Cardboard package inserts

Quick Start Guide
Programming software (MAPware-7000), cables, and power
supply purchased separately.
Panel Mounting and Panel Cutout:
HMC7070A-M
Tighten the mounting screws evenly to a torque between 0.6
and 0.7 nm to maintain water and dust resistance. Make sure
the panel is not dirty and warped and that it is strong enough
to hold the unit.
Note: Maximum panel thickness (on which unit is to be
mounted) should be 6.0mm (tolerance: +0.00mm and -
0.05mm).
Specifications:
.
Doc. No. 1011-7070AM
The HMC7070A-M is a combination operator-based HMI
(Human Machine Interface) with built-in PLC (programmable
logic controller) operation. It communicates with external
PLCs over an Ethernet port, or serial communications port to
read/write data. Up to five I/O expansion modules can be
attached.
Power:
Display:
Bezel:
Touchscreen:
LED:
Memory:
Ethernet:
Serial Ports:
USB Slave:
USB Host:
Operating Temp:
Humidity:
Dimensions:
Panel cutout:
Mounting Unit to Panel:
Step 1: Place unit into cutout of panel and position mounting
clamps (four) into side slots of HMC7000 enclosure as shown
above.
Step 2: Tighten clamps evenly to prevent warping. Continue to
tighten until a torque force of 0.6-0.7 nm is obtained.
Step 3: HMC7000 should be aligned evenly with the cutout
with no warping present after clamps are tightened.
Port Details (COM1 and COM2):
Maple Systems Inc. 808 134th Street SW, Suite 120, Everett, WA 98204-7333 • www.maplesystems.com
24VDC + 15%, 9W
7" TFT(800x480 pixels)
Color graphics display
NEMA 4 (IP 66) rated
4-wire analog resistive
One Power LED
10 MB Max. Application Memory
One Ethernet port (Project Upload/
download and PLC communications)
Two serial ports (RS232/RS485/RS422)
Upload/download projects
Data Storage
0 to 50° C
10% to 90% (non-condensing)
7.68 x 5.59 x 1.97 inches
[195x142x50mm]
7.24 x 5.16 inches
[184x131mm]
Page 1 of 2
DB9S (Female) Connector
Grounding:
The HMC7000 should have a good electrical connection to
earth ground via the power connector for safety and to reduce
electrical noise. The HMC unit should be grounded separately
from other high-power systems.
Note: Do not use a ground connection that has potential
impedance (such as painted screws) or is subject to vibration.
Expansion I/O Modules:
The HMC7070A-M has five expansion slots that you can use to
connect I/O modules. Consult Maple Systems website for a
complete listing of modules currently available.
Rev. 01, 03/13/18