Table of Contents
Advertisement
CLEAR ALL TOOLS AWAY FROM
WORK AREA AND CONNECT TO
THE MAINS SUPPLY!
1. Make sure the speed control dial is turned right down
and press the power switch, see fig 8.
Fig 08
2. Press the 'GREEN' button, the 'LED' indicator comes
on and the lathe starts, see fig 09.
3. Turn the the speed control dial to the required speed,
see fig 10.
PRESS THE RED BUTTON TO
STOP THE LATHE AND SWITCH
OFF THE POWER.
Drive & Live Centre Removal
To remove the drive and live centres, locate the push rod (H), while holding the live centre insert the push rod
through the centre hole of the tailstock wheel and push the live centre out. Repeat the procedure for the drive
centre in the headstock, see fig 11-12.
Fig 11
OPERATING INSTRUCTIONS
DISCONNECT THE LATHE FROM
THE MAINS SUPPLY!
9
Fig 09-10
Fig 12
Advertisement
Table of Contents
