Universal Control (Windows) - PRESONUS AudioBox USB 96 Owner's Manual

AudioBox USB®96
3 Connecting to a Computer
Power User Tip: It is recommended that you temporarily disable or turn off
any anti-virus programs you have running to prevent installation issues.
用户提示： 建议你暂时禁用或关闭你正在运行的任何反病毒程序，以防止安装问题。
3.1.1

Universal Control (Windows)

Sample Rate. Changes the sample rate.
Sample Rate. 改变采样率。
You can set the sample rate to 44.1, 48, 88.2, or 96 kHz. A higher
sample rate will increase the fidelity of the recording but will
increase the file size and the amount of system resources
necessary to process the audio.
你可以将采样率设置为 44.1、48、88.2或96kHz。更高的采样率将提高录
音的保真度，但会增加文件的大小和处理音频所需的系统资源量。
Safe Mode. Adjusts the Input Buffer Size.
Safe Mode. 调整输入缓冲区大小。
These modes allow you to adjust the input buffer size to optimize
performance for your computer.When adjusting the safe mode, the block
sizewillbeadjusteautomaticallytoprovidethebestperformance.
这些模式允许你调整输入缓冲区的大小，以优化你计算机的性能。当调整
安全模式时，块大小将被自动调整，以提供最佳性能。
Block Size. Sets the buffer size.
Block Size。设置缓冲区的大小。
From this menu, you can set the buffer size from 64 to 8192
samples. Lowering the buffer size will lower latency; however, this
will also increase performance demands on your computer. In
general, you will want to set the buffer size as low as your system
can safely support. If you begin to hear pops, clicks, or distortion in
your audio path, try raising the buffer size.
从这个菜单中，你可以设置64到8192个样本的缓冲区大小。降低缓
冲区大小会降低延迟；但是，这也会增加对你的计算机的性能要求。
一般来说，你想把缓冲区的大小设置到你的系统可以安全支持的最
低限度。如果你开始听到音频路径中的爆音、咔嗒声或失真，请尝
试提高缓冲区大小。
10