[b] STARTER
1) Turn off the power supply.
2) Remove the Front Panel.
3) Remove the Control Box Cover.
4) Disconnect the terminals from the Starter.
5) Remove the Starter.
6) Install the new Starter.
The Starter is position-sensitive. Install it so that the arrow indication of the
Starter can point upward. Failing to install it in this way will cause abnormal
operation and adversely affect the Compressor operation as well.
7) Connect the terminals.
8) Assemble the removed parts in the reverse order of which they were removed.
9) Turn on the power supply.
13. REMOVAL AND REPLACEMENT OF DISPENSING SYSTEM
[a] AGITATOR
1) Turn off the power supply.
2) Remove the Front Panel.
3) Remove the Bin Front Panel.
4) Remove the Thumbscrews and pull off the Gear Motor Bracket.
Note: Hold the Agitator so as not to drop it when pulling off the Gear Motor Bracket.
5) Replace the Agitator with the new one.
6) Assemble the removed parts in the reverse order of which they were removed.
7) Turn on the power supply.
WARNING
64