Removal And Replacement Of Dispensing System; Dispensing Auger And Agitator; Dispensing Or Agitating Motor - Hoshizaki DT-400BAH-OS Service Manual

Cubelet icemaker / dispenser
Hide thumbs Also See for DT-400BAH-OS:
Table of Contents

Advertisement

13) Open the water supply line shut-off valve.
14) Plug the icemaker back in and move the control switch to the "ICE" position.
15) Allow the icemaker to fill for two minutes.
16) Move the control switch to the "OFF" position and unplug the icemaker from the
electrical outlet.
17) Check for water leaks.
18) Plug the icemaker back in and move the control switch to the "DRAIN" position, and
make sure water is draining into the drain pan, and that there are no water leaks
around the hose connection. Confirm the drain hose is located in the drain pan.
19) Move the control switch to the "OFF" position.
0) Replace the cabinet stand panels in their correct positions.
1) Move the control switch to the "ICE" position to start the automatic ice making process.
J. Removal and Replacement of Dispensing System

1. Dispensing Auger and Agitator

1) Move the control switch to the "OFF" position.
) Unplug the icemaker from the electrical outlet.
3) Remove the upper front panel.
4) Remove the front cover of the storage bin.
5) Remove the thumbscrews, first from the vertical plane and then from the horizontal
plane of the motor brackets.
Note: Hold the dispensing auger/agitator to prevent it from dropping when pulling off
the gear motor bracket. See Fig. 6.
6) Replace the dispensing auger/agitator with the new one.
7) Assemble the removed parts in the reverse order of which they were removed.
8) Plug the icemaker back in. Move the control switch to the "ICE" position to start the
automatic ice making process.

2. Dispensing or Agitating Motor

1) Move the control switch to the "OFF" position.
) Unplug the icemaker from the electrical outlet.
3) Remove the upper front panel.
4) Remove the storage bin front panel.
5) Remove the thumbscrews, first from the vertical plane and then from the horizontal
plane of the motor brackets.
Note: Hold the dispensing auger/agitator to prevent it from dropping when pulling off
the gear motor bracket. See Fig. 6.
6) Remove the packing, three flat head screws, and plastic guide.
5

Advertisement

Table of Contents
loading

Table of Contents