Maintenance; Disposal And Recycling - Scheppach HL760LS Original Instruction Manual

15. Maintenance

Attention!
Pull out the power plug before carrying out any mainte-
nance work on the equipment.
We recommend:
• The splitting wedge is a wearing part that needs to
be sharpened or replaced after wear.
• The combined gripping and controlling device must
remain smooth running. Lubricate with a few drops
of oil when necessary.
• Keep splitting wedge drive clean of dirt, wood shav-
ings, bark, etc.
• Lubricate slide rails with grease.
When must the oil be changed?
Change the oil after 150 working hours.
Oil change (fig. 17 - 20)
1. Move the log splitter into the start position and pull
out the mains plug.
2. Undo the oil drain screw with dipstick (8) and put it
to one side. (fig. 18)
3. Turn the log splitter on the support leg side as
shown in fig. 19 over a 4 liter capacity container
to drain the hydraulic oil off. Recycle carefully! Dis-
pose of the waste oil in an environmentally friendly
manner!
4. Turn your machine on the motor side as shown in
Fig. 20 to refill about 3,5 l fresh oil.
5. Clean the oil drain screw with dipstick (8) and
screw it back in to the machine that is still in a ver-
tical position. Unscrew it again; there should be an
oil film between the two notches. (Fig. 17)
6. Now screw the oil drain screw with dipstick back
in tightly. Afterwards start splitting without actually
splitting log several times.
7. Check the oil level one last time and top up with a
little oil if required.
Dispose of the used oil in a correct manner at a
public collection facility. It is prohibited to drop
old oil on the ground or to mix it with waste.
We recommend oil from the HLP 32 range.
Connections and repairs
Connections and repairs of electrical equipment may
only be carried out by an electrician.
Please provide the following information in the
event of any enquiries:
• Type of current for the motor
• Machine data - type plate
• Motor data - type plate
Service information
Please note that the following parts of this product are
subject to normal or natural wear and that the following
parts are therefore also required for use as consum-
ables.
Wear parts*: riving knife, hydraulic oil, riving bar guide
* Not necessarily included in the scope of delivery!
Spare parts and accessories can be obtained from our
service centre. To do this, scan the QR code on the
cover page.

16. Disposal and recycling

special waste. Ask your dealer or your local council.
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE). This product must be
disposed of at a designated collection point. This can
occur, for example, by handing it in at an authorised
collecting point for the recycling of waste electrical and
electronic equipment. Improper handling of waste
equipment may have negative consequences for the
environment and human health due to potentially haz-
ardous substances that are often contained in electri-
cal and electronic equipment. By properly disposing
of this product, you are also contributing to the effec-
tive use of natural resources.
www.scheppach.com
The equipment is supplied in packaging to
prevent it from being damaged in transit.
The raw materials in this packaging can be
reused or recycled. The equipment and its
accessories are made of various types of
material, such as metal and plastic. Defec-
tive components must be disposed of as
GB | 29