Table of Contents
Advertisement
pack should be in good contact. If
something goes wrong, it needs to be fixed
before it can be charged.
11 During charging and discharging, try to
avoid water or other conductive objects
splashing on the battery cover and pole.
12 Avoid charging at low temperature (below
0 ℃) to ensure battery life
Dry Battery Filling and
Charging Instructions
1
Remove the battery vent caps and
permanently remove the plastic seal from
the battery vent openings.
2
Fill each cell with battery acid (electrolyte)
until the level is sufficient to cover the
plates.
Do not fill to maximum level until the battery
charge cycle is complete. Overfilling can
cause the battery acid to overflow during
charging. Neutralize battery acid spills with
baking soda and water.
3
Install the battery vent caps.
4
Charge the battery.
5
Check the battery acid level when the
charging cycle is complete. Replenish with
distilled water to the bottom of the fill tube.
Do not overfill.
Note: In order to achieve an optimal service
life, discharge of over 60% of the rated
capacity should be avoided. Discharge of over
80% of the rated capacity is a deep discharge
and is not permissible. These significantly
reduce the service life of the battery. Only
those discharge state indicators that have
been approved by the battery manufacturer
may be used.
Discharged batteries must be charged
immediately and must not remain in
OPERATOR'S MANUAL with Maintenance Information
Operating Instructions
discharged state. This also applies to batteries
in a state of deep discharge. Otherwise, the
service life of the battery will be significantly
reduced. The battery may freeze when in
discharged state
Charge the battery immediately when the
machine displays "36" or "68" alarm code
during work.
During the charging process, if temperatures
are consistently higher than 40°C or lower
than 15°C, stop charging to check whether the
battery and charger are normal..
61
Advertisement
Table of Contents
