Table of Contents
Advertisement
At the Platform Controls
Test Emergency Stop
20 Push in the platform red Emergency Stop
button to the off position.
⊙ Result: No functions should operate.
21 Pull out the red Emergency Stop button to
the on position.
⊙ Result: The LED indicator light should
come on.
Test the Horn
22 Push the horn button.
⊙ Result: The horn should sound.
Test Function Enable and Up/Down
Functions
23 Do not hold the function enable switch on
the control handle.
24 Slowly move the control handle in the
direction indicated by the blue up arrow,
then in the direction indicated by the yellow
down arrow.
⊙ Result: No functions should operate.
25 Press the lift function select button.
26 Press and hold the function enable switch
on the control handle.
27 Slowly move the control handle in the
direction indicated by the blue up arrow.
⊙ Result: The platform should raise. The
pothole guards should deploy.
28 Release the control handle.
⊙ Result: The platform should stop raising.
29 Press and hold the function enable switch.
Slowly move the control handle in the
direction indicated by the yellow down
arrow.
⊙ Result: The platform should lower. The
OPERATOR'S MANUAL with Maintenance Information
descent alarm should sound while the
platform is lowering.
Test the Steering
Note: When performing the steer and drive
function tests, stand in the platform facing the
steer end of the machine.
30 Press the drive function select button. The
indicator light should turn on.
31 Press and hold the function enable switch
on the control handle.
32 Depress the thumb rocker switch on top of
the control handle in the direction identified
by the blue left arrow on the control panel.
⊙ Result: The steer wheels should turn in the
direction that the blue left arrow points on
the control panel.
33 Depress the thumb rocker switch in the
direction identified by the yellow right
arrow on the control panel.
⊙ Result: The steer wheels should turn in the
direction that the yellow right arrow points
on the control panel.
Test Drive and Braking
34 Press the drive function select button. The
indicator light should turn on.
35 Press and hold the function enable switch
on the control handle.
36 Slowly move the control handle in the
direction indicated by the blue up arrow on
the control panel until the machine begins
to move, then return the handle to the
center position.
⊙ Result: The machine should move in the
direction that the blue up arrow points on
the control panel, then come to an abrupt
stop.
37 Press and hold the function enable switch
on the control handle.
43
Function Tests
Advertisement
Table of Contents
