Table 3-1 Status Leds Boot Definitions - Cisco 11500 Series Hardware Installation Manual

Booting the CSS for the First Time
Table 3-1
Table 3-1
State Sequence
1.
2.
3.
4.
5.
If an error occurs during a test, the console displays an error message, increments
the detected error counter, and continues to the next test until it completes all of
the power-on self tests. For more information on errors and messages, refer to
Appendix C, Troubleshooting.
Cisco 11500 Series Content Services Switch Hardware Installation Guide
3-4
defines the boot states and the Status LEDs blinking patterns.
Status LEDs Boot Definitions
Power up, flash scan, and power-on self test
occur.
Power-on self test detects an error.
The CSS 11501 or a module in the CSS 11503 or
CSS 11506 is off line and active.
The CSS 1150 or a module in the CSS 11503 or
CSS 11506 module is on line and not active.
In the CSS 11506, a passive SCM LED remains
in this state and color.
The CSS 11501 or a module in the CSS 11503 or
CSS 11506 is on line and active.
The CSS 11501 or a module in the CSS 11503 or
CSS 11506 (except a Fast Ethernet Module)
fails.
If a Fast Ethernet Module fails in the CSS 11503
or CSS 11506, all of its Link and Duplex LEDs
blink simultaneously.
In the CSS 11503 or CSS 11506, when the
master SCM in slot 1 detects a module failure, its
Status LED is green and blinks slowly.
When the master SCM in slot 1 fails, the CSS
does not boot unless there is a passive SCM in
slot 2.
Disk activity
Chapter 3 Booting and Configuring the CSS
LED Color
Amber
Red
Amber
Amber
Green
Red
Green
LED State
Fast blink
Solid
Slow blink
Solid
Solid
Blinking
Variable
blinking
78-13884-03