Table 1-2 Status Leds Boot Definitions - Cisco CSS 11501 - Content Services Switch Getting Started Manual

Booting the CSS on a Routine Basis
The hardware then goes through a series of power-on self tests. The asterisks that
appear indicate the completion of each test.
Press <ESC> to enter the Diagnostic Monitor
* * * * * * * * * * * * * *...
Ran
During the power-on self tests, the Status LEDs blink and change color to indicate
the stages of the boot process. The left Status LED is bicolor, green or red. The
right Status LED is amber.
The Ethernet connectors on the CSS 11501 and the 8- and 16-port Fast Ethernet
Modules on the CSS 11503 or CSS 11506 do not contain Status LEDs. Each
Ethernet connector has Link and Duplex LEDs to indicate the state of the
connection.
Table 1-2
Table 1-2
State Sequence
1.
2.
3.
Cisco Content Services Switch Getting Started Guide
1-8
1 times, x tests. Detected 0 errors.
defines the boot states and the blinking patterns of the Status LEDs.
Status LEDs Boot Definitions
The CSS powers up, scans flash, and performs a
power-on self test.
The CSS powers on and a self test detects an
error.
The CSS 11501 or a module in the CSS 11503 or
CSS 11506 is offline and active.
The CSS 11501 or a module in the CSS 11503 or
CSS 11506 is online and not active.
In the CSS 11506, a passive SCM LED remains
in this state and color.
Chapter 1 Booting, Logging In, and Getting Started
LED Color
Amber
Red
Amber
Amber
LED State
Fast blink
Solid
Slow blink
Solid
OL-6037-01