Adjustment Procedure - JUKI MF-7900 Series Engineer's Manual

❸

2) Adjustment procedure

WARNING :
As the work is performed while the power is ON, never touch the switches other than the necessary
one so as to prevent accidents caused by the malfunction of switches.
❻
❹ ❺
❷
❶
Elastic band
❷
❶
❷
❶
4. Installing the rear roller
(1) Fix rear roller plate base ❶ with three wood
screws ❷ .
(Reference) For the installing position of the
rear roller plate base ❶ , refer to the
drawing of the table.
(2) Install rear roller (asm.) ❸ to rear roller plate
base ❶ with screw ❹ (M8), washer ❺ and
clamp lever ❻ .
1. Adjusting the lateral position
Adjust the position so that the right-hand end of
the elastic band fits collar ❶ of the front roller
when placing the elastic band straight to the
front roller.
(1) Loosen screw ❷ , adjust collar ❶ to the
position of the right-hand end of the elastic
band, and tighten screw ❷ .
(Caution) Do not excessively tighten screw ❷ .
Deformation of the collar ❶ will be
caused.
2) Adjusting the vertical position
Loosen clamp lever ❶ , and adjust the height of
front roller ❷ .
(1) Adjust the position in accordance with the
length of the elastic band, and tighten clamp
lever ❶ .
– 150 –