2) Adjustment procedure
WARNING :
As the work is performed while the power is ON, never touch the switches other than the necessary
one so as to prevent accidents caused by the malfunction of switches.
❾
Air hose
A
1.
Adjusting the position of the binder
Perform the adjustment of the position of binder
❾ with screws .
2.
Adjusting the open/close amount of the binder
Adjust the open/close amount of the binder with
collar .
3.
Adjusting the speed of open/close of the binder
The speed of open/close of binder ❾ can be
changed with speed controllers and .
When you desire to change the opening speed
of binder ❾ , loosen the nut of speed controller
located on the machine side and turn the
adjustment screw.
When you desire to change the closing speed of
binder ❾ , loosen the nut of speed controller
located on the operator side and turn the adjust-
ment screw.
After the adjustment, tighten nuts of speed con-
trollers and .
4.
Adjusting the air regulator
(1) Insert the air hose to air regulator .
(2) Use the air pressure at 0.4 to 0.5 MPa (4 to
2
5 kgf/cm
).
(3) Draw up knob of regulator , turn knob
and adjust the pointer to 0.4 to 0.5 MPa
to adjust the air pressure.
(4) After the adjustment, press downward knob
of regulator .
(5) When drainage is collected at section A of
regulator during using, press drain cock
to discharge the drainage.
– 148 –