Pulling direction for remov-
ing the hood parts
•
•
•
The sensor can only be screwed on in one position as a result of the cylin-
drical pin.
•
•
The mechanical assembling of the sensor is thus finished
Remove the two-piece hood from the sensor.
Remove the protection cap for transportation from the sensor element.
Mount the sensor on the measuring block. Take notice of the correct
installation position of the sensor.
Fasten the sensor to the measuring block using a socket wrench
(size 36).
Latch both halves of the hood back between the sensor and the
measuring block in the roll pins.
5 Installation
Alignment pins for hood
(2-part)
Hood (2-part)
Protection cap for transporta-
tion for sensor tip
25