Mounting - Ei Electronics Ei600 Series Instruction Manual

2.6 Mounting

WARNING: to prevent injury, this apparatus must be securely attached to the ceiling or wall in
accordance with the installation instructions.
1. Select a location complying with the advice in Section 2.
2. Remove the mounting plate from the Alarm by
twisting it in an anti-clockwise direction (see Figure
6).
3. Place the mounting plate on the ceiling exactly where
you want to mount the Alarm. With a pencil, mark the
location of the two screw holes.
4. Taking care to avoid any electrical wiring in the ceiling,
drill holes using a 5.0mm drill bit through the centre of
the marked locations. Push the plastic screw anchors
provided into the drilled holes. Screw the mounting
plate to the ceiling.
5. If using an RF interconnection, ensure all Alarms are
facing the same direction. This means picking a part
of the building, say the front of the building and then
installing all mounting plates in the same orientation
with respect to this (see Figure 8).
6. Carefully line up the Alarm on the mounting plate,
press down gently and twist on.
Fig.6
ROTATE UNIT ANIT-CLOCKWISE
IF THE UNIT HAS BEEN TAMPERPROOFED,
IT WILL NOT TWIST OFF - SEE FIGURE 8c
21