Daktronics PPX-1050 Series Quick Manual

PPX-1050 Series Panel Installation & Service Quick Guide
Basics
Display Accessories
Standard display accessories include the following:
• Lifting tool
• Key
• Power input cable
• Signal input cable
Figure 1: Lifting Tool Figure 2: Key
Figure 3: Power Input Cable Figure 4: Signal Input Cable
Storage & Shipping
Panels are stored and shipped in
wood crates with four panels per
crate. The depth of the crate is
980 mm, and the height and width
vary by panel size. Refer to the table
below and Figure 5.
Crate Size Panel Size
940x1240 mm 640x1120 mm
940x1400 mm 640x1280 mm
1100x1240 mm 800x1120 mm
1100x1400 mm 800x1280 mm
Figure 5: Wood Crate
DD5004860
Rev 00
05 January 2022
Mechanical Installation
Panel Installation
Note: Two people are required for the steps in this section.
1. Use a pry bar to remove the crate lid, exercising caution to prevent
damage to the LED panels in the crate. Refer to Figure 6.
Figure 6: Remove Crate Lid Figure 7: Remove Crate Side
2. Use a pry bar to remove the crate side, exercising caution to prevent
damage to the LED panels in the crate. Refer to Figure 7.
3. Use the supplied lifting tool as an additional handle and remove the
panel from the crate. Refer to Figure 8.
Figure 8: Remove Panel from Crate Figure 9: Stand Panel on Ground
4. Use the side handles on the panel to stand the panel upright on the
ground. Refer to Figure 9.
201 Daktronics Drive
Brookings, SD 57006-5128
www.daktronics.com/support
800.325.8766
5. Verify the existing jump cable on the panel is a female-to-male
connection. Refer to Figure 10 and Figure 11.
Figure 10: Female Connector Figure 11: Male Connector
6. Use the supplied key to unlock the top locks and slide the top cover
back to remove the cover. Refer to Figure 12 and Figure 13.
Figure 12: Unlock Top Locks Figure 13: Remove Top Cover
7. Use the lifting holes to lift the panel. Refer to Figure 14 and Figure 15.
Figure 15: Lift Panel
Figure 14: Lift Panel
8. Repeat Steps 3-7 for any additional panels.
Page 1 of 3
45°
minimum