Mipi-Dsi0; Mipi-Csi {0/1; I2C {2/3; Hsic - Arrow SD 600eval Hardware User Manual

7.2.1 MIPI-DSI0

The 96Boards CE specification calls for a MIPI-DSI to be present on the High Speed Expansion Connector. A minimum of one lane
is required and up to four lanes can be provided on the connector.
The SD 600eval board implementation supports a full four lane MIPI-DSI interface that is routed to the High Speed Expansion
Connector.

7.2.2 MIPI-CSI {0/1}

The 96Boards CE specification allows for optional two MIPI-CSI interfaces to be present on the High Speed Expansion Connector.
CSI0 interface can be up to four lanes while CSI1 is up to two lanes.
The SD 600eval board implementation supports a full four lane MIPI-CSI 2.0 interface on CSI0 and two lanes of MIPI-CSI 2.0 on
CSI1 port. All MIPI-CSI signals are routed directly to/from the APQ8064

7.2.3 I2C {2/3}

The 96Boards CE specification allows for two optional I2C interfaces to be present on the High Speed Expansion Connector for
MIPI-CSI interface implementation.
SD 600eval implements I2C on High Speed Expansion Connector for MIPI-CSI interface.
For MIPI-CSI0 the companion I2C2 is routed directly from the APQ8064 to High Speed Connector.
For MIPI-CSI1 the companion I2C3 is routed directly from the APQ8064 to High Speed Connector.
I2C lines are pulled up with 2.2K resistor at 1.8V voltage level.

7.2.4 HSIC

The 96Boards CE specification allows for optional HSIC interface to be present on the High Speed Expansion Connector.
The SD 600eval board implementation supports this optional requirement. The HSIC signals of APQ8064 are routed directly to
High Speed Expansion Connector.

7.2.5 Reserved

The 96Boards CE specification calls for a 100K pull-up to 1.8V to be connected at pin 60 of the High Speed Expansion Connector.
The SD 600eval board supports this requirement.

7.2.6 SD/SPI

The 96Boards CE specification calls for an SD interface or a SPI port to be part of the High Speed Expansion Connector.
The SD 600eval board supports this requirement, APQ8064 SDC2 Port signals are routed to High Speed Expansion Connector.

7.2.7 Clocks

The 96Boards CE specification allows for optional programmable clock interfaces to be provided on the High Speed Expansion
Connector. These clocks may have a secondary function as master clock for camera ports.
The SD 600eval board implements two CSI Master Clocks, CSI0_MCLK via APQ GPIO_5 and CSI1_MCLK via APQ GPIO_2. These
signals are driven at 1.8V.

7.2.7 USB

The 96Boards CE specification calls for USB interface to be present on the High Speed Expansion Connector.
Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com. Arrow.com.
Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from Downloaded from
.
23/30