Install The Handle And Shift Rod - Toro Line Painter 1200 Operator's Manual

Install the Handle and Shift
Rod
1. Remove the hairpin cotter, washer and cable tie
securing the shift rod for shipping (Fig. 2). Retain
hairpin cotter and washer for installation of the shift
rod.
2. Remove the (2) bolts, spacers and nuts securing the
handle to the tank support (Fig. 2). Discard the bolts,
spacers and nuts.
3
Figure 2
1. Shift rod
2. Handle
3. Using the lower set of holes, loosely mount the handle
to the tank support with (2) bolts (Fig. 3).
1
Figure 3
1. Lower mounting hole
2. Upper mounting hole
3
1
2
3. Bolt, spacer & nut (2)
3
2
3. Handle
4. Select one of the upper mounting holes, position the
handle at the desired operating position and secure the
handle to the tank support with (2) bolts and nuts
(Fig. 3).
5. Insert the upper end of the shift rod into the hole in the
shift linkage (Fig. 4). Secure the rod end to the linkage
with the washer and hairpin cotter previously removed.
3
1. Shift rod
2. Shift linkage
6. Insert the rod fitting onto the shifter bell crank shaft
and secure with a washer and a hairpin cotter (Fig. 5).
1. Rod fitting
2. Shift rod
7. Tighten the bolts and nuts.
8. The rod should be adjusted so the machine shifts
smoothly into all gears. Adjust the rod fitting, up or
down, as required.
9. Tighten the handle cable ties and cut off excess.
10
2
1
Figure 4
3. Washer & hairpin cotter
3
2
1
Figure 5
3. Washer & hairpin cotter