Toro Line Painter 1200 Operator's Manual page 20

1
Figure 28
1. Tank strainer
1. Remove the paint tank strainer (Fig. 28) and clean
with water.
2. Open the paint tank drain valve (Fig. 29). The farther
the drain valve is opened the more paint is allowed to
drain.
Figure 29
1. Paint tank drain valve
3. Inside the paint tank, insert the agitation line into the
drain valve, as shown in figure 30.
1. Agitation line
4. Start the engine which allows the pump to circulate.
5. Make sure the Flush/Paint lever (Fig. 31) is in the
PAINT position.
6. Allow the engine to operate for 5 to 10 seconds to
pump the remaining paint out of the system.
1
1. Flush/Paint Knob
7. Actuate the paint control lever and lock it open with
the locking latch. This will allow the nozzle to flush
continuously.
8. Rinse paint tank with clean water. Continue to fill tank
with water until the nozzle sprays clean water.
Note: If the flush system has been used, move the
flush/paint lever to the flush position for 15 seconds or
until the nozzle sprays clean water.
9. Remove and clean the pump filter. Refer to Cleaning
the Pump Filter.
20
2
1
Figure 30
2. Tank drain valve
Flush
Off
1
Paint
Figure 31