Table of Contents
Advertisement
3-10
[0] Return to Main Menu
1
[1] Stop Test
[2] Inject Single Bit Error (ST only)
[3] Reset Counters
Current Test:
Test Status:
Test Duration:
Bit Errors:
Next Selection:
1
displays "Restart Test" when Test Status is "Stopped"
2
displays name of test selected from Diagnostic Selection screen;
identifies Network Line Loopback and DTE Local Loopback
tests as either Unilateral or Bilateral
3
or "Stopped"
4
or "NO SYNC"; displays only while a Self Test is selected
Figure 3-4 Diagnostics Results Screen
Monitor
The terminal interface DeskTop T1 Monitor function displays a screen
of status information concerning DTE interface signals and alarm
conditions.
Figure 3-5 illustrates the Monitor screen.
The DTE Status portion of the screen displays the current status of
nine DTE interface signals as OFF, ON, or TRANS. TRANS indicates
that the signal is transitioning, as opposed to being in a prolonged On
GDC 048R154-000
DT T1 Diagnostics
Network QRSS Self Test
Running
x minutes, y seconds
0000 e00
Operation
2
3
4
Advertisement
Table of Contents
