Connections; Dte Interface Port Connection; Network Connection; Back Panel Connectors - General DataComm DeskTop T1 Installation And Operation Instruction Manual

Installation

Connections

Network Interface Port –
RJ48C
Network Business Equipment
Console Port –
for connection of VT100-compatible
Figure 2-2 Back Panel Connectors

DTE Interface Port Connection

The DeskTop T1 DSU provides one ITU-T V.35-compatible DTE
interface port. The port is a 34-pin female (V.35) connector located on
the rear panel. Refer to Table 1-1 for the appropriate interface cable.
Refer to Appendix B for interface pin/signal assignments.

Network Connection

Connect the network (T1 line) to the DeskTop T1 DSU as described
below.
The Telco continuously monitors the T1 link and the
equipment connected to it. Notify the Telco before
connecting the DeskTop T1 DSU to the network. The
NOTE
DeskTop T1 DSU must remain continuously powered on and
connected to the T1 service. FCC Part 68 rules require the
user to notify the service provider if the DSU is removed
from service or turned off.
DTE Interface Port –
ITU-T V.35 34-pin connector
terminal
2-13
Console POWER
AC Power Cord
Connection
GDC 048R154-000