RMG WMTWLI Installation Manual

Wireless Multi-Tank Water Level Indicator with
It is a Radio Frequency Based Level Indicator which helps to ascertain the level of water
in the tank. It also gives alarm when tank is empty or tank full. The maximum range of the line
of site is 500 to 1000 meters (Can be used in a 10 storey building / apartment). The device is
portable and wireless and free from hassles of wiring. It has transmitter and receiver units. The
transmitter unit is placed near the water tank, whereas the receiver unit is placed inside the
house for monitoring four levels to get alert for tank empty or full.

TRANSMITTER UNITS:

 AC 230V supply should be given for the transmitters.
 Sensors should be placed in the respective water tank at Common, 25%, 50%, 75%,
100% level and has to be connected with this transmitter. Colour coding will be labelled
in the respective transmitters.
 There is a yellow colour switch that helps for pairing with the indicator.
 It checks the water level in the tank every 32 seconds once. It sends the data to the
Common Receiver (Indicator Unit) if there is any change in the water level of the Tank.

INDICATOR UNIT:

 Has Power ON/OFF switch. AC 230V input supply must be given to this unit.
 There are 4 level indications for the tank.
 Gives a slow beep when tank level is low (All LEDs will be OFF) and fast beep when the
tank is full (All LEDs will be ON).
 The alarm will beep for 15-30 seconds.
 Mute button is used to stop the alarm as well as used for pairing the transmitters and
receiver.
Description
Single tank indicator
Dual tank indicator
Triple tank indicator

PAIRING PROCEDURE:

The units are generally paired and dispatched. In case of any trouble at the time of
installation, users can pair the units once again.
 Step 1: Give Input AC 230V to the Receiver / Indicator Unit.
 Step 2: Press the MUTE button and do not take the finger out. While doing this, switch
ON the power ON/OFF switch. All the LEDs will blink on the tank level. It means the
device is ready for pairing.
 Step 3: Give Input Supply AC 230V for the Transmitter unit.
 Step 4: Long press the pairing switch (yellow switch) of the Transmitter. Without taking
out the finger from the pairing switch, switch ON the power ON/OFF switch. The
receiver unit is now paired with Transmitter.
Web: www.rmgautomation.com
Tank Empty & Tank Full Alarm
Transmitter
1 no.
2 no.
3 no.
eMail: rmgworld@hotmail.com
(WMTWLI) - Installation Manual
Receiver
1 no.
1 no.
1 no.
Contact: 044 - 43180017
1