Table of Contents
Advertisement
12.6
Installing the fork legs
SERVICE WORK ON THE CHASSIS 12
–
Loosen screws
–
Loosen screws
H03680-10
Main work
–
Position the fork legs.
Bleeder screws
Info
The compression damping is located in left fork
leg COMP (white adjuster). The rebound damping is
located in right fork leg REB (red adjuster).
Grooves are milled into the side of the upper end of
the fork legs. The second milled groove (from the top)
S04824-13
must be flush with the upper edge of the upper triple
clamp.
–
Tighten screws
Guideline
Screw, top triple
clamp
–
Tighten screws
Guideline
Screw, bottom triple
clamp
H03680-11
–
Position the brake caliper, and mount and tighten screws
Guideline
Screw, front
brake caliper
–
Mount the cable ties.
–
Position the brake line, the wiring harness, and the clamp.
Mount and tighten screws
S04422-11
Finishing work
–
Install the front wheel.
–
Install the headlight mask with the headlight. (
–
Check the headlight setting. (
3
. Remove the left fork leg.
4
. Remove the right fork leg.
1
are positioned toward the front.
2
.
M8
17 Nm (12.5 lbf ft)
3
.
M8
15 Nm (11.1 lbf ft)
M8
25 Nm (18.4 lbf ft)
5
.
(
p. 98)
p. 114)
4
.
®
Loctite
243™
p. 111)
57
Advertisement
Table of Contents
