Power Supply Specifications - Mitsubishi GO T1000 User Manual

3.3 Power Supply Specifications

Item
Input power supply voltage
Fuse (built-in, not
exchangeable)
Power consumption
At backlight off
Inrush current
Permissible instantaneous
power failure time
Noise immunity
Dielectric withstand voltage
Insulation resistance
Applicable wire size
Applicable solderless terminal
Applicable tightening torque
(Terminal block terminal
screw)
Remark
Operation at momentary power failure
GT1155-QSBD
24VDC (+10% -15%), ripple voltage 200mV or less
1.0A
9.84W (410mA/24VDC) or less
4.32W (180mA/24VDC) or less
15A or less (26.4V) 2ms
Within 5ms
Noise voltage: 1000Vp-p, Noise width: 1 s (by noise simulator of 30 to 100Hz noise
frequency)
500VAC for 1 minute (across power supply terminals and earth)
10M or larger by insulation resistance tester (across power supply terminals and
earth)
2
0.75 to 2[mm ]
Solderless terminal for M3 screw RAV1.25-3, V2-N3A, FV2-N3A
0.5 to 0.8[N•m]
The GOT continues to operate even upon 5ms or shorter instantaneous power
failure.
The GOT stops operating if there is extended power failure or voltage drop, while it
automatically resumes operation as soon as the power is restored.
Specifications
GT1150-QLBD
9.36W (390mA/24VDC) or less
3.3 Power Supply Specifications
1
2
3
4
5
6
7
8
3 - 4