Table of Contents
Advertisement
A
p
p
e
n
d
i
x
D
A
p
p
e
n
d
i
x
D
U U
p p
U
p
The subsystem is shipped with firmware installed. You may however wish to install new
or upgraded editions of the firmware. Ask your vendor about the latest firmware edition.
Once new or updated firmware has been obtained, it can be downloaded to from a host
PC with third party communication software, such as HyperTerminal, that supports ANSI
terminal emulation. Other terminal programs may be used in place of HyperTerminal to
communicate with the subsystem. However, the setup process for other terminal
software may differ from that outlined in this chapter.
1. Ensure is turned off.
2. Connect one end of the supplied
RS-232 cable to the RS-232 port on
the rear of and connect the other end
to one of the host computer's COM
ports.
d d
a a
t t
i i
n n
g g
F F
d
a
t
i
n
g
F
Array data and configurations are not affected by updating of firmware.
HyperTerminal is bundled as standard with Microsoft Windows operating
systems. It will be found in the Communications folder. The program can also
be downloaded from Hilgraeve Software at http://www.hilgraeve.com/htpe/
-D-1-
Appendix D – Updating Firmware
i i
r r
m
w w
a a
r r
e e
m
i
r
m
w
a
r
e
Advertisement
Table of Contents
