Table of Contents
Advertisement
RIBBON IC ERROR
RIBBON
UNSUPPORTED
RIBBON UNKNOWN
DOOR OPEN
CARD JAM / NEXT
An error occurs in the chip.
The wrong ribbon is used on this
printer.
The ribbon can not be recognized.
The ribbon door is open or does not
close well.
Card jam in the device.
carefully re-install it to its proper position.
3. Please clean the chip on the side of the ribbon and
re-install the ribbon.
4. Please make sure the ribbon door is closed.
If the error message still occurs, please contact your
nearest HiTi distributor or HiTi customer service
center. Website:
1. Please clean the chip on the side of the ribbon and
re-install the ribbon on the card printer.
2. If the error message still exists, please install a new
ribbon.
If the error message still occurs, please contact your
nearest HiTi distributor or HiTi customer service
center.
Website:http://hi-ti.com
Please install the correct ribbon.
Please install the correct ribbon.
Please close the ribbon door again.
Please remove the card by following the instructions
on the printer LCD monitor before continuing the
print job. Please press [OK] to get step by step
instructions.
1. OPEN THE DOOR: Open the ribbon door to see
if the card and the ribbon are sticking together.
2. TAKE OFF THE RIBBON: Remove the ribbon.
There are three options for the removal of a jammed
card. Please press [<] or [>] to select one of these
options:
AUTO REMOVE CARD: Press [OK], the
card printer will show "MOVING CARD"
and remove the card automatically.
SEMI-AUTO REMOVAL: Press [OK], the
LCD
display
BUTTON", press [<] or [>] to remove the
card. After removing the cards, press [OK] to
clear the error message.
MANUAL REMOVAL: Press [OK], the
LCD display will display "REMOVE BY
HAND". After removing the card, press [OK]
to clear the error message.
※ ※ ※ ※ NOTICE！ ！ ！ ！ During "SEMI-AUTO
REMOVAL" or "MANUAL REMOVAL"
process, please DO NOT put your hands into
the card printer.
※ ※ ※ ※ NOTICE！ ！ ！ ！ If the LCD display does not show
"NEXT" below the "CARD JAM" message,
please empty the rejected box and then continue
the
troubleshooting
computer monitor.
※ ※ ※ ※
！ ！ ！ ！ If the card printer is performing the
NOTICE
double-side printing, and any "Card jam" error
occurs after printing the first side, please follow
then the previous instructions to remove the
card and check if the cleaning roller is installed
properly. If not, please follow the instructions
in "1-4 Install Cleaning Roller" to install the
cleaning roller.
42
http://hi-ti.com
will
show
"CONTROL
process
through
www.hi-ti.com
the
Advertisement
Table of Contents
