Table of Contents
Advertisement
Cam TPH error
The error occurs in the mechanism.
Cam pinch error
Cam flipper error
Cam Mag error
Check sum error -
SDRAM
Check sum error –
SRAM
The version of the firmware is not
correct.
Check sum error –
FLASH
Check sum error –
Wrong firmware
Nvram R/W error
The error occurs due to memory inside
the card printer.
Nvram CRC error
Command sequence
The error occurs due to command
error
sequence.
Your PC adopts USB 1.1 Host
USB
connection
Controller, and uses other USB devices
was broken
(Including other HiTi printers) at the
same time.
Some USB devices and HiTi printer
Trying to re-connect
plug into the same USB 1.1 host
to the device, please
controller, and both work at the same
wait a moment
time, there might be some kind of USB
conflict and this may interrupt the
printing job.
Press the 'Cancel" button to restart the card printer. Or
download the latest version of firmware from HiTi
website and follow the instructions from the HiTi Card
Printer User Manual to re-install the firmware.
If the error message still occurs, please contact your
nearest HiTi distributor or HiTi customer service center.
Website:
http://www.hi-ti.com
Please restart the card printer. If the error message still
occurs, please contact your nearest HiTi distributor or
HiTi customer service center.
Website:
http://www.hi-ti.com
Please restart the card printer or download the latest
Firmware from HiTi website and follow the instruction
from HiTi Card Printer User Manual to re-install the
firmware.
If the error message still occurs, please contact your
nearest HiTi distributor or HiTi customer service center.
Website:
http://www.hi-ti.com
1. Please do not use any other USB devices at the same
time to avoid USB compatibility problems if your PC
is using a USB 1.1 Host Controller.
2. To avoid any kind of USB compatibility problem,
please upgrade your PC to USB 2.0 Host Controller.
Notice:
You can check version of the Host Controller via
"Control Panel/ System/ Hardware/ Device Manager/
USB Universal Host Controller". It is USB 2.0 Host
Controller if you see "xxx xxxx Enhanced Host
Controller xxxx".
1. You can either upgrade your computer to USB 2.0 or
stop operating the other USB device while the HiTi
printer is printing.
2. You can try to switch the other USB device into a
different
USB
CheckUsb.exe, to check if there is any conflict in the
USB connection. (For CheckUsb.exe, please contact
HiTi customer service center.)
40
port
and
use
the
www.hi-ti.com
program,
Advertisement
Table of Contents
