Hi-Touch Imaging Technologies CS-300 User Manual page 38

Ribbon out The ribbon has been used up.
The card printer does not detect the
Ribbon missing
ribbon.
The ribbon is not installed or the ribbon
is installed in an improper position or
Door open
the ribbon door is in the correct
position.
Ribbon IC R/W
An error occurs in the chip.
error
Unsupported ribbon Wrong ribbon for this printer.
Unknown ribbon The ribbon can not be recognized.
1. Please install a new ribbon.
2. Please follow the instructions from the LCD display to
switch the ribbon sensors (Please refer to Chapter 3,
section 2, the description of RIBBON 1)
If the error message still occurs, please contact your
nearest HiTi distributor or HiTi customer service center.
Website: http://www.hi-ti.com
1. Please make sure the ribbon is present.
2. Please make sure the ribbon has been installed
properly.
3. Please clean the chip on the side of the ribbon and
re-install the ribbon to the card printer.
4. Please close the ribbon door properly.
If the error message still occurs, please contact your
nearest HiTi distributor or HiTi customer service center.
Website: http://www.hi-ti.com
1. Please check if the ribbon is present.
2. Please make sure the ribbon has been properly
installed, remove and re-install the ribbon if necessary.
3. Please close the ribbon door to the proper position.
1. Please remove the ribbon.
2. Please clean the chip in the side of the ribbon and
re-install the ribbon.
3. If the error message still exists, please install a new
ribbon.
4. If the error message still occurs, please contact your
nearest HiTi distributor or HiTi customer service center.
Website: http://www.hi-ti.com
Please install the correct ribbon.
Please install the correct ribbon.
38
www.hi-ti.com