Table of Contents
Advertisement
．CLEANING MODE
．．CARD OUT SNR
．．ADF SENSOR SEL
．．PUT CLEANING KIT &
OPEN
THE
DOOR
CLEAN PROCESSING
} }
29
The
sensor
for
card-insert mechanism. (ENABLE /
DISABLE). The default setting is
[DISABLE].
However,
switch [DISABLE] to [ENABLE] and
there are no cards in the Card Input
Hopper, the error message [CARD
OUT] will be shown on the LCD
display. If the [Card Out] message
continues to exist, even after you
have inserted cards into the Card
Input
Hopper
and
computer,
then
[ENABLE] to [DISABLE] and refer to
Chapter 5 Troubleshooting→ "The
Error
Message
Computer
Monitor
Solutions"→ "Card out or feeding
"
error
OR
"The Error Message
shown on the LCD Display and the
Solutions" → "CARD OUT". After
above
procedures
message still persists, please contact
the HiTi customer service center.
The sensors for card (ADF SENSOR
1/ADF SENSOR 2). When the card
feeding process fails, you can try to
switch ADF SENSOR 1 or ADF
SENSOR 2 for troubleshooting. If the
problem can not be resolved, please
refer to Chapter 5 Troubleshooting→
"The Error Message shown on the
Computer
Monitor
Solutions"→ "Card out or feeding
"
error
OR
"The Error Message
shown on the LCD Display and the
Solutions" → "CARD OUT". After
above procedures fail and if the card
feeding process still fails, please
contact the HiTi customer service
center.
Please follow the instruction on the
LCD Display. Remove the peel-off
&
film from the cleaning card. Insert the
cleaning card and open the ribbon
door. Press [OK] button to initiate the
cleaning process.
cards
in
the
once
you
restart
your
please
switch
shown
on
the
and
the
if
this
error
and
the
www.hi-ti.com
Advertisement
Table of Contents
