Table of Contents
Advertisement
1. The printer will detect the printing
temperature automatically. When the
temperature is overheated, the printer
will stop printing temporarily and
cool the temperature down. The card
printer
temperature will be below 60 ℃.
Thermal print head
overheat
2. When you continue printing more
than 5 to 10 pages, the temperature
might be higher so that the printer
must cool down its temperature.
3. This message also occurs when the
When an internal error occurs, an error message will display this error on the
LCD display. The error messages and their solutions are listed below:
The Error Message is displayed on the LCD Display and on the
Solutions
The Error Message
CARD OUT
CARD MISMATCH
RIBBON OUT
RIBBON MISSING
will
continue
temperature is overheated in the
operating environment.
Possible Causes
There is no card in the Card Input
Hopper.
The card size is not correct.
The ribbon has been used up.
The card printer does not detect the
ribbon.
until
the
1. Please wait a while until the thermal printing head
cools down, and the printer will restart automatically.
2. Please use the card printer in an indoor environment
with air conditioning.
1. Please check if there is any card in the Card Input
Hopper;
2. Please check if the selected thickness of the card
matches the card.
3. Verify the weight used.
4. Please make sure the cards are not sticking to each
other.
If you still can not solve this problem, please refer to
the following procedures:
1. If this error message appears after you place the
cards with printed back side into the Card Input
Hopper, please switch CARD OUT SNR to
[DISABLE] through the LCD display.
2. The error occurs after feeding a card,
If you are printing a magnetic stripe card,
please confirm that the card feeding direction
is correct.
If you use double-magnetic cards or the card
with printed back side, please switch ADF
SENSOR to SENSOR2 through LCD display.
Please insert the standard CR-80 cards.
1. Please replace it with a new ribbon.
2. Please follow the instructions from the LCD
display to switch the ribbon sensors (Please refer to
Chapter section 2, the description of RIBBON 1)
If the error message still occurs, please contact your
nearest HiTi distributor or HiTi customer service
center.
Website:http://hi-ti.com
1. Please check if the ribbon is present.
2. Please make sure the ribbon is in the proper
position. If you are not sure, please remove and
41
Solutions
www.hi-ti.com
Advertisement
Table of Contents
