7. OPENING VAULT WITH PROGRAMMED FINGERPRINT
With keys in hand, close and lock the door.
Place and hold the programmed finger
on the scanner and indicator ring will
illuminate green and the vault will unlock.
You can now open your vault.
If your print is not accepted:
you will see 1 light flash with 1
sound. This means the scanner
did not read your fingerprint
(try again).
IMPORTANT: If you see 5 red
flashes with 5 sounds, the scanner
read your fingerprint but did not
accept it. Follow section 6 to
reprogram your fingerprint.
8. PROGRAMMING ADDITIONAL FINGERPRINTS
When accessing your vault quickly, there is a chance you may touch
the scanner with a part of your finger that you have not registered before.
For this reason, we recommend programming additional areas of your
fingerprint to ensure fast and reliable entry to your vault.
INDIVIDUALLY MAPPING ALL
ZONES OF YOUR FINGERPRINT
WILL ENSURE A RELIABLE
READING BY THE SCANNER.
To ensure each programming
sequence is properly captured, it
needs to read the exact same place
on your finger four times in a row,
once successful you can move onto
the next zone of your fingerprint.
This counts as one programmed
fingerprint of 100 fingerprints this
unit can keep in memory.
Once programming sequence has
been successfully completed, you
can move onto the next zone of your
fingerprint.
INDICATOR RING
TRY AGAIN
RED
1
x
LIGHT
1
x
TIP
TOP
MIDDLE
REPROGRAM
RED
5
x
LIGHT
5
x
10